General • Re: simple 3 isp dhcp clients with aggregation
hi,have uploaded my latest config. btw, what i am doing is: testing a openvpn and wireguard server. i.e. the server is in vlan 2 and i am connecting to it from a client which is in vlan 1. thus i...
View ArticleForwarding Protocols • Re: IEEE1588 PTPv2 support for CRS317
Hi dgel27,I am still working on a reliable PTP config for the CRS326-24S+2Q+. I have a working config that runs well with some RU's, even in a 100Mhz 4x2 config but some other RUs don't work well and...
View ArticleRouterBOARD hardware • mikrotik mUPS?
what happened to that device? https://mikrotik.com/product/mupsi knew it existed, now was planning an outdoor instalation with outdoor UPS and this thing is nowhere to be found.Statistics: Posted by...
View ArticleRouterBOARD hardware • Re: mikrotik mUPS?
The discontinued MikroTik product is not the best for do that, and do not have any battery inside...You read the instruction?For example, the product do not convert 12V input (from battery) to 24V...
View ArticleGeneral • Re: MLAG problem?
I encountered problems with Cisco port channels connected to MikroTik CRS317 RouterOS 7.14.3 too.Code: Eth1/22 sw-1 vpcCmpFai trunk full auto 10Gbase-LRUsingCode: # sho vpc consistency-parameters vpc...
View ArticleWireless Networking • Re: Connecct cAp to hap ax2
There are 2 versions of capsman: legacy and wifiwave2.cAP as in RBcAP2nD uses legacy wifi.hAP AX2 uses wave2 wifi.Depending on which device acts as your controller, it might be possible to have both...
View ArticleWireless Networking • Re: Cube 60 Pro ac
Wanted to ask why 5Ghz is connection so slow?HiBecause the 5 GHz link is not used now5GHz link is not used (reserve)Code: # 2024-04-26 15:21:41 by RouterOS 7.14.3status: connected-to-esschannel:...
View ArticleClik here to view.
Beginner Basics • IPv6 firewall filter not filtering
I receive messages in my log like the following:DROP IPv6 forward: in:<wan-interface> out:<guest-interface>, connection-state:invalid src-mac <fritz-box-ip-address>, proto TCP (RST),...
View ArticleSwOS • Re: ports dont link after device reboot
SwOS 2.16 was released and it still seems to have the same problem. Tested on a CRS309-1G-8S+. Only thing I didn't do was removing power to the device after the upgrade to see if that changes...
View ArticleGeneral • Re: Help with inter VLAN routing (seems to work except web interface?)
Are you sure you want this to happen?It's an OpenSpeedtest server that I'd like to also be accessible from the outside. Would adding "in-interface=pianetafibra_pppoe" restrict the rule enough? I'm...
View ArticleClik here to view.
Beginner Basics • Re: iPhone L2TP Issues
Despite this being an issue for months across 2 different sites, performing the troubleshooting in my original post and replicating the issue on a router with a basic config, this issue suddenly...
View ArticleBeginner Basics • Re: hap AX3 - HW offloaded Bridge - traffic leak
Currently, HW offloaded bridge support for the IPQ-PPE switch chip is still a work in progress. We recommend using, the default, non-HW offloaded bridge (enabled RSTP)....
View ArticleRouterOS beta • Re: RB5009 Slow Speed 2.5G Bug Report (as requested)
Gahhhh! I have this same problem... So one thing I've noticed is that on a device connected at 1Gbps everything is fine bidirectionally... UNTIL there's some delay added... Add some delay on a linux...
View ArticleWireless Networking • hap ax3 802.11b possible in /wifi/capsman?
Hello,I'm setting up a new hap ax3 in my existing network (RB952Ui-5ac2nD). I would like to setup wifi2.4, wifi5 and wifi6 with the hap ax3. Importance fact: I have devices that requires...
View ArticleScripting • Re: script
Install an OS designed to be scripted from the ground up, then use that to netinstall your routers. One of many possible expressions of this basic philosophy is this article.This is meant as...
View ArticleGeneral • Get Two public IP on the same interface
Hello for all..from your experience can you share how can you get two public IP address on the same interface..?I mean the following :I have ONU device connected to Mirkotik in ether1 interface.in...
View ArticleGeneral • Dual WAN - what setup is recommended?
Hello, i need better understand how to set dual WAN the correct wayCurrently i have most basic setup - pppoe in port 1 made by quick set, router mode + i added 4 wireguards (and firewall rules). ISP1...
View ArticleForwarding Protocols • MPLS TE Paths buggy ros7?
It seems MPLS TE paths have issues in ros7 still?I can create a path from cli, and it works fine, however the path does not display in winbox.Conversely, if I create a path in winbox, it does not...
View ArticleWireless Networking • Re: hap ax3 802.11b possible in /wifi/capsman?
From what I understood: leave it to AX and it should automatically remain backwards compatible down to 802.11b.Statistics: Posted by holvoetn — Fri Apr 26, 2024 5:54 pm
View ArticleGeneral • Re: Dual WAN - what setup is recommended?
sorry not familiar with ipv6 so cannot assist.Statistics: Posted by anav — Fri Apr 26, 2024 5:56 pm
View Article