Adding to this topic as I believe I am having the same issue. I am quite new to MT products. I have a HAP AX3 (only a few weeks, replaced pfSense VM to isolate Network from Server) and am using stock config (QuickSET). I also have a CRS326 in SWOS for a few years now, but clearly am not using it to its full potential.)
I have success with WireGuard App on a Windows Client PC connecting from outside connection (via DuckDNS) and I can see the handshake in WinBox. But I can't get anywhere once I make the handshake. My intent is to get to my ProxMox Web Interface should I need to from outside the home network.
I think my main issue is I don't know how to route the WireGuard Subnet to the LAN subnet.
I have attached my config file as I saw was instructed earlier. i tried comparing the two, but I just don't understand enough of the command line at this time to make my way through it.
Any suggestions would be greatly appreciated!
Unkis
I have success with WireGuard App on a Windows Client PC connecting from outside connection (via DuckDNS) and I can see the handshake in WinBox. But I can't get anywhere once I make the handshake. My intent is to get to my ProxMox Web Interface should I need to from outside the home network.
I think my main issue is I don't know how to route the WireGuard Subnet to the LAN subnet.
I have attached my config file as I saw was instructed earlier. i tried comparing the two, but I just don't understand enough of the command line at this time to make my way through it.
Any suggestions would be greatly appreciated!
Unkis
Statistics: Posted by unkis17 — Fri Mar 08, 2024 4:44 am