Basis steps:
- use Winbox for access since it allows MAC access if you mess up IP settings
- remove all firewall rules on filter and NAT tabs (this will prevent your lockout already)
- all ports to bridge except ether2
- IP address of device connected to bridge (don't forget route settings then!) or DHCP client to bridge (like you want, use fixed DHCP assignment on your router so it always gets the same IP)
- setup wireless
- make sure those wireless interfaces are also added to bridge
- setup ether2 like you want (own IP address etc etc)
- use Winbox for access since it allows MAC access if you mess up IP settings
- remove all firewall rules on filter and NAT tabs (this will prevent your lockout already)
- all ports to bridge except ether2
- IP address of device connected to bridge (don't forget route settings then!) or DHCP client to bridge (like you want, use fixed DHCP assignment on your router so it always gets the same IP)
- setup wireless
- make sure those wireless interfaces are also added to bridge
- setup ether2 like you want (own IP address etc etc)
Statistics: Posted by holvoetn — Fri Feb 28, 2025 9:50 am