Since im thrilled with the new interface list option for the switches and the bridge.. I was trying to get all of my switches flash figged to my set up with this configuration. But at first I was having an error that said "device-mode" wasn't allowing it. So I then made some changes and it let me change the boot mode to flash-boot. But now it just doesnt work and im connecting to the switch on port 1
this is the CRS318-16-2S+OUT.
and config is like this for my ether1 port
And I can reach and configure my switch on that port. I download the latest version of flash fig. and for whatever reason after the reboot.. it just doesnt take.. Im lost.
And router board config I like this every time I reboot and im plugged into port 1..
Any help would be greatly appreciated.. ive been doing this for my event switches for a few years now with no issues.. not sure whats going on now..
Firmware is up to date btw
this is the CRS318-16-2S+OUT.
Code:
system/device-mode> print mode: advanced allowed-versions: 7.13+,6.49.8+ flagged: no flagging-enabled: yes scheduler: yes socks: yes fetch: yes pptp: yes l2tp: yes bandwidth-test: yes traffic-gen: no sniffer: yes ipsec: yes romon: yes proxy: yes hotspot: yes smb: yes email: yes zerotier: yes container: no install-any-version: no partitions: no routerboard: yes attempt-count: 0 Code:
/interface bridge portadd bridge=bridge comment=defconf frame-types=admit-only-untagged-and-priority-tagged interface=ether1 internal-path-cost=10 \ path-cost=10 pvid=200 trusted=yesAnd router board config I like this every time I reboot and im plugged into port 1..
Code:
/system routerboard settingsset boot-device=flash-boot-once-then-nandFirmware is up to date btw
Code:
/system/routerboard> print routerboard: yes board-name: netPower 16P model: CRS318-16P-2S+ serial-number: firmware-type: dx3230L factory-firmware: 6.48.6 current-firmware: 7.17 upgrade-firmware: 7.17 Statistics: Posted by joshhboss — Thu Jan 30, 2025 3:26 am