Beginner Basics • Re: WiFi Station to Ethernet Port

I don't understand.

The mAP lite has only one ethernet port, ether1.

You want to connect your radio (wlan1) to an existing wi-fi network?
Then the device is a "client" or "station" (and not an AP).

And - it depends on choices - it can be configured both as "router" (with wlan1 as WAN and ether1 as LAN) or as a "switch" (with both wlan1 and ether1 in a bridge).

If it is a router and the Wi-FI is "unknown" it is not a very good idea to connect without a firewall, on the other hand if it a "trusted Wi-FI" a bridge configuration would be simpler and avoid double NAT, (but of course you can have the router configuration without a firewall), but I see a few perplexing settings in your configuration:

there is seemingly no "mode" in /interface wirelesswhich should be either station bridge (if the wi-fi network AP is also Mikrotik) or station pseudobridge (if the wi-fi network AP is not Mikrotik), *like*:

/interface wireless
set [ find default-name=wlan1 ] band=2ghz-b/g/n country=italy disabled=no \
installation=indoor mode=station-pseudobridge security-profile=Pixel6a ssid=Pixel

There is a LTE interface:
which cannot exist on a mAP lite.

And ovpn/hotspot/ipsec/bfd settings that seem to have no reason to exist.

The rest seems just fine.

So please check the setting in /interface wireless, then post your configuration again.
Post also the output of:and of:
so that we can check that dynamic addresses are assigned and dynamic routes are created.

Statistics: Posted by jaclaz — Fri Jan 10, 2025 7:48 pm

---