I'm having a little issue trying to get the CRS326 to work like the Dell Switch. The managed Dell switch has a couple vlans on it but only one is being used from the main router RB1100AHx4 (vlan100) using 10.107.100.x addresses. I can't seem to get the CRS326 to grab an IP from the main router, the CRS326 bridge is set to grab an ip from the dhcp client that the bridge is on. I'm not sure if I need to make the CRS326 a static IP instead and then make the necessary ports for vlan100.
The Dell Switch managed ports goes as follows in main network closet:
Ports are on vlan100
port 1(Dell vlan1 trunked) goes to port 2 on Mikrotik RB1100AHx4(vlan100-ip addresses 10.107.100.x)
port 4 (Dell) goes to another switch (MT crs326 bridged) in another room from there is a cable run across a parking lot connected by a couple MT GEPR to a Netgear passthru switch that feeds 2 ports on stacked Dell fiber switch OOB
also have 2 ports that feed a OOB on a stacked Dell Fiber switch in our main network closet.
This replacement of the Dell with a CRS326 feeds also 4 cluster hosted servers. I would like it if the new MT switch can easily work but its not going so easily.
The Dell Switch managed ports goes as follows in main network closet:
Ports are on vlan100
port 1(Dell vlan1 trunked) goes to port 2 on Mikrotik RB1100AHx4(vlan100-ip addresses 10.107.100.x)
port 4 (Dell) goes to another switch (MT crs326 bridged) in another room from there is a cable run across a parking lot connected by a couple MT GEPR to a Netgear passthru switch that feeds 2 ports on stacked Dell fiber switch OOB
also have 2 ports that feed a OOB on a stacked Dell Fiber switch in our main network closet.
This replacement of the Dell with a CRS326 feeds also 4 cluster hosted servers. I would like it if the new MT switch can easily work but its not going so easily.
Statistics: Posted by CenturyG — Mon Dec 30, 2024 6:28 pm