Beginner Basics • Fresh installation issues.
Hello,I'm not new to routers but i am new to RouterOS 7.17. Currently using a Ubiquiti Edgerouter 3 lite (And some previous trials with PFsense/Opnsense).I took a Dell Optiplex and installed RouterOS...
View ArticleWireless Networking • Re: Groove Wireless WAN
If I get your configuration right, the groove is set up as a bridge between the wlan and an ether interface, then the hap is set up as a "normal" router between the thus bridged WAN and the local LAN...
View ArticleGeneral • Re: WiFi CAPs recommended way to configure VLAN IDs?
Since you have only AX devices:Using datapath settings on capsman controller, you can already split your wifi channels into other vlans.It is not needed per se to use trunks on caps, caps mode on...
View ArticleGeneral • ROS Port isolation on CRS328-24P
Hello!I need some help to configure port isolation on CRS328-24P with ROS.I have 2 different subnets on core router (10.1.0.0/23 on port2 and 10.4.0.0./23 on port2) isolated by firewall.On CRS328 i...
View ArticleGeneral • L2TP/ipsec hAP AX2 low speed ROS 7.17
Hi!After upgrading to ROS 7.17.x, there was a problem with low l2tp/ipsec speed. The speed does not exceed 70/70 mbps.L2TP client - hap ax2, server - Linux Debian.Encoding: cbc(aes) + hmac(sha1). sha1...
View ArticleGeneral • Re: WireGuard SMB and Throughput Problems
Are there any suggestions for fixing the throughput issue?Statistics: Posted by dazzaling69 — Tue Feb 11, 2025 8:45 pm
View ArticleClik here to view.
General • Quectel BC68 UDP problem
Hello,I’m trying to send and receive UDP packets to my server. As far as sending the packet is concerned, it’s no problem. But when I try to receive a packet nothing ever arrives. In the photo you can...
View ArticleBeginner Basics • Re: Fresh installation issues.
If you use a DHCP client,besides the configuration you need to post also the output of commands:Code: /ip address printandCode: /ip route printso that we can see also the Dynamic part of the...
View ArticleGeneral • I CANNOT PING BETWEEN 2 LANS ON THE SAME MIKROTIK.
Hello,I am doing static routing with mikrotik through a radio link. I cannot PING between ether 5 interfaces (where I have a LAN connected, with network 192.168.60.0) and ether 3 (where the link is,...
View ArticleGeneral • Re: Another Find question
What is far more important is that the string that follows the ~ operator is not a text constant - it is a regular expression, so you can e.g. set that string to "e....1" when matching on the...
View ArticleGeneral • Re: L2TP/ipsec hAP AX2 low speed ROS 7.17
In case it is reproducible like described you should file a bug report at Mikrotik support system. See https://mikrotik.com/supportStatistics: Posted by infabo — Tue Feb 11, 2025 9:20 pm
View ArticleGeneral • USB support for FT4232H
Is it possible to add FT4232H support to RouterOS? RouterOS correctly supports single USB to RS232 ports, but does not correctly detect the FT4232H module which provides 4 serial ports.In principle,...
View ArticleBeginner Basics • Re: VLAN on a single port
Circling back on this...So if I'm just fine being able to access the dmz from a single port on the same switch chip, what's my next step: setting up a bridge on one of the chips between the dmz, the...
View ArticleGeneral • Re: I CANNOT PING BETWEEN 2 LANS ON THE SAME MIKROTIK.
First problem I see is that you are showing 10.0.0.4 as the gateway, but there is no 10.0.0.4 device on your network drawing.Statistics: Posted by k6ccc — Tue Feb 11, 2025 10:06 pm
View ArticleGeneral • Re: Bandwith monitoring via SNMP
Hello,I'm monitoring my routers with the TIG solution by using SNMP for my telegraf.Hi,I'm trying to do the same. On a miniPC I've a Casaos Debian ,Installed Grafana , InfluxDB and telegraf.When try...
View ArticleClik here to view.
General • Re: Secrets in supout.rif
It's not about trust, it's more about privacy. And comments could be a private thing sometimes.You don't show people what's in your pants even if you trust them Well ... if you're asking urologist for...
View ArticleWireless Networking • Re: WIFI roaming for WPA3 broken again (somewhere from...
Interesting ...So question is ... why this (that MAC ignoring) is not applied also to the FT-WPA2-PSK clients, only to WPA3-PSK clients.I will add this discovery to the support ticket I created.Thank...
View ArticleBeginner Basics • Re: Route scope and status confusion
OK, part of my confusion is that I was looking at /routing/route instead of /ip/route. But the /routing/route active and unreachable properties aren't set:Code: [admin@Palace] /ip/route> :put...
View ArticleThe User Manager • User-Manager RADIUS-proxy
Hi!I have a little specific problem.We use Mikrotik routers by many of our companies with Microsoft NPS as RADIUS server.But with the new User Manager (v7) we want to use the OTP function for MFA...
View ArticleGeneral • Restore on version 7.17.2
I had a Chateau12 (D53G-5HacD2Hn) running ROS 7.16.0. After I upgraded to 7.17.2 the WireGuard interface was no longer working. I then wanted to restore my version 7.16.0 backup using the Winbox...
View Article