Wireless Networking • Re: hAP ax3 wireless problem
Huh. The replies in this thread are indeed very interesting. I apologize for being perhaps a bit rude in my previous comments. I was too much annoyed about what in my eyes was a lack of proper...
View ArticleGeneral • Re: Mikrotik rb750gr3 fasttrack and wireguard issue
Mangle and fasttrack are not compatible. When mangling is needed (I'm assuming ypu need it as you created quite a few mangle rules), then easiest way out is to completely disable fasttrack. This in...
View ArticleGeneral • Re: Loss of speed
enable fasttrackStatistics: Posted by baragoon — Fri Jan 12, 2024 12:32 pm
View ArticleWireless Networking • Re: Video/Audio calls hangs for 0.5-2 seconds each 5-15...
No errors but still hangs.One of the laptops is now connected via LAN cable to RB4011 and do not see any hangs during a calls.Another laptop is connected via WiFi and see hangs during a calls. At same...
View ArticleGeneral • Re: IPIPv6 Tunnel bandwith for RB3011, RB4011 and RB5009.
Were you able to test IPIP(v4) usage scenario where there is Fast Path allow-fast-path=yes to increase the performance?No, i do not have an IPIP(v4) tunnel to try that. My provider is IPv6 native,...
View ArticleGeneral • Routing over IPsec tunnel through the remote network
Hello Im a beginner in this field, Im currently stuck at this point . i've tried everything and the problem still there.Im using IPSEC IKEV2 Policy Based VPN on Huawei to connect to Mikrotik office.To...
View ArticleForwarding Protocols • Re: Bgp- signaled vpls and l3vpn issues in 7.10
Hi Everyone,Quick update/question on this topic.We have successfully configured BGP Signaled VPLS (L2VPN) and BGP VPN (L3VPN) on a GNS Project where we are developing a OSPF / IBGP Service Provider...
View ArticleGeneral • Re: New Router
Hello every1!The lightning struck our office building and ate my old RB2011. Unfortunatly this is where i ran my Capsman server. I have 6 wap ac r2’s as AP’s and they did survived the lightning.Im...
View ArticleGeneral • Q: How to bridge filter MNDP within a VLAN?
For completeness, I have attached my bridge configuration below.The point is that I do have a VLAN 400 across an EOIP connection to another installation.To and from the remote installation, the router...
View ArticleForwarding Protocols • Re: ROS 7.11 BGP Routereflector Redundancy
Hi Zarade,The best solution is to have all the IBGP routers on your network establish two bgp sessions (i.e. one session to each route reflector). In this way both route reflectors will always have...
View ArticleForwarding Protocols • Re: Single Area vs Multiarea OSPF
Hi SpudrageousWe are currently developing a GNS3 prototype for a multi-area OSPF network where OSPF will distribute PtP and Loopback addresses. iBGP will run on top of this to distribute customer...
View ArticleAnnouncements • Re: v7.13.1 [stable] is released!
FWIW my AX2 (currently on 7.13) has never reboot since Dec 28th when I applied that version.Simply using it as AP though via RB5009 capsman controller.Same setup, AX’ses are crashing, pretty much,...
View ArticleGeneral • IP and route configuration for /28
Good day everyone!I'm sorry if this question is an obvious one but I'm a little bit confused on how to configure my router (CCR2004-16G-2S+) with a /28.I have been given this information by my ISP:(of...
View ArticleGeneral • Unable to Connect over Port 9001
Hi,I am quite confused over this.I have a fingerprint attendance device which is unable to connect to a cloud server using port 9001 when it is behind Mikrotik.Connecting the device directly to the...
View ArticleScripting • Re: add succesfully connected rdp to whitelist
Theoretically, it is possible to try to analyze the ratio of input and forward packets to the RDP port for each address, but there is no certainty that this will give anything. Such a task will...
View ArticleClik here to view.
RouterBOARD hardware • Ceiling AP + "LED Ceiling Lights" in one...
Looking to replace our Ceiling Lights for LED's and thought how great would that beto have "cAP ax" acting as well as a "LED Ceiling Light"supporting PWR-LINE and have maybe movement sensor etc....
View ArticleForwarding Protocols • Re: Disable ECMP on OSPF?
Even if you somehow disable ECMP, you will still have "unpredictable routing".Only instead of having ECMP routes, which at least are easily seen in the routing table, you can end up with asymmetric...
View ArticleGeneral • Re: AWS instance running WireGuard from hEX S router fails
Which device is acting as server for handshake?Would need to see the wireguard settings for AWSAlso full config of MT router/export file=anynameyouwish ( minus router serial number, public WANIP...
View ArticleGeneral • Re: Connection through WireGuard for a list of users
Would need to see full config on MT/export file=anynameyouwish ( minus router serial number, public wanip information, keys etc )Statistics: Posted by anav — Fri Jan 12, 2024 2:11 pm
View ArticleScripting • Re: Useful scripts
The function of obtaining an array of subnets between two ip4 addresses. May be useful for organizing addresses database. The order of the transmitted addresses does not matter.Code: # return common...
View Article