General • Re: Ip Address print command
It's just a visual separator...Statistics: Posted by dang21000 — Fri Dec 27, 2024 10:33 pm
View ArticleGeneral • hardware x86 vs ARM64bit HW offloading full routing BGP
Hello everyone, I have a question, I would like to ask for your opinion to make a decision, I want to do full BGP routing, the 1072 doesn't allow it, so I was thinking if I could use the brute force...
View ArticleGeneral • IPv6 SLAAC wrong prefix
This is my IPv6 config:Code: [admin@fw-xxx0-0] > /ipv6 export# 2024-12-27 22:08:31 by RouterOS 7.14.3# software id = JLI2-LN5C## model = CCR1009-8G-1S-1S+# serial number = xxx/ipv6 addressadd...
View ArticleWireless Networking • Re: Capsman : scheduled provisioning per config
Not sure (haven't tried it), but it sounds like something you should be able to do with VLAN's, simple queues and scheduler. But it depends on your use case. What policies should be in...
View ArticleGeneral • Re: Winbox on arm64
Hello,Winbox 3.xx is currently working quite well on arm64. I'm not a power user on Winbox, but to me all the base feature are working well.To make it work, it's a serious imbrication of emulation !...
View ArticleGeneral • Re: static Names with DNS
1. via dhcp-server you have to send the IP of your router in LAN/ip dhcp-server network set dns-server=192.168.88.1 domain=name.local2. open port for DNS in firewall/ip/firewall/filter add...
View ArticleGeneral • Re: IPsec tunnel not working RB951
Yes and no. The summary is that with that action=none policy in place, the ICMP "packet too large" messages were indeed sent to the LAN host, but it was not enough to make the traffic pass through the...
View ArticleGeneral • Re: DHCPv6 client not assigning the received address on NIC
Which ROS version? Only newer v7 versions correctly display dynamic IPv6 addresses and routes, older versions (including all v6 versions) omit them from print command. Addresses and routes are there...
View ArticleScripting • Wireguard Peers reset script
Hello, i've experienced an issue... my (smartphone's or other device) endpoint ip remain stuck in the WG peer Endpoint address, and i am unable to reconnect. The only way is to deactivate/reactivate...
View ArticleRouterBOARD hardware • Re: MikroTik CRS310-8G-2S+-IN Random 2.5G Port Failure
I've read that this switch is equiped with 2 glued heatsinks and they can also get out due too bad glue and not correct heat dissipation.Can you open the unit and check the heatsink state ?I've few...
View ArticleClik here to view.
General • Re: hap ax3 random wireless disconnects
Honestly, for WiFi I'm starting to evaluate something else.dtim-period=1 is the default, you could try a bit higher, like 3.Why evaluate something else, if 7.14.3 is working for you. Why upgrade at...
View ArticleClik here to view.
General • Re: Remote reverse proxy with mikrotik
First. If the traffic is from the local network to the outside and has to go through a proxy. This is called such a proxy service and not reverse proxy.Secondly, you have redesigned the problem....
View ArticleAnnouncements • Re: v7.17rc [testing] is released!
I had problems when I attempted to upgrade my RB5009 running Capsman - many devices refused to connect to my 5 GHz wifi (noted iphones and Macbook). Basically, it looked like all devices connected to...
View ArticleBeginner Basics • VPN ipsec - no local LAN client access
I've installed Router OS CHR and setup an Ipsec vpn . I'm able to connect from remote client and I receive a correct IP address from DHCP server but I cannot access anything on my LAN except the...
View ArticleForwarding Protocols • Re: Mikrotik v7 BGP l2vpn-evpn
There is, the high-end ones has the hardware. But no support implemented yet.Statistics: Posted by mada3k — Sat Dec 28, 2024 3:33 pm
View ArticleClik here to view.
General • [solved] Re: Restrict IPv6 access
I just reading about SLAAC first local auto-generated address (fe80::/64), check for duplication (DAD), get the prefix from the router and construct the address via mechanism you describe.Already...
View ArticleGeneral • Re: Cannot access Lan devices over vpn client
you should add this Code: /interface listadd include=dynamic name=LANadd name=WANnoooo .. wrong suggestionStatistics: Posted by gianry — Sat Dec 28, 2024 3:53 pm
View ArticleGeneral • Re: Do AP's come with all router functions?
No HTTPS? Only HTTP, Telnet, and SSH for local access?How accurate is Mikrotik overlay for firewall rules? Without seeing actual tables, I can't even judge whether GUI applies what I think it...
View ArticleGeneral • Re: VPN failed after speedtest
Hi,I'm experiencing the same thing but my RouterOs is CHR version so no Fast track.Every time I try to do a Speedtest from remote client the VPN tunnel goes down.Statistics: Posted by gianry — Sat Dec...
View ArticleGeneral • Re: hardware x86 vs ARM64bit HW offloading full routing BGP
If I install ESXI on the x86 server and install RouterOS on it, I could use VPP/DPDK. Thank you very much for your reply.Statistics: Posted by oscar789 — Sat Dec 28, 2024 5:34 pm
View Article