General • Re: Get public IP when router is behind NAT and gets private IP
Thanks for that, it works in my script. My script-fu is poor, hard to maintain it when you don't use it regularly.Statistics: Posted by sbotnick — Fri Dec 08, 2023 4:57 am
View ArticleBeginner Basics • EoIP: guarantee MTU of 1500
I'm planning a workaround to bridge interfaces of a legacy wireless station with interfaces of wifiwave2 AP. Since station-bridge is out, the plan is to use an EoIP tunnel as a VLAN trunk.The wireless...
View ArticleWireless Networking • Re: CAP - no connections to CAPSMan
Problem is that you are mixing two versions of CAPsMAN.On your RB960 you have v1 and on your cAP ax you have v2.You need to install wifiwave2 package on your router but for MIPSBE i don't think it's...
View ArticleRouterBOARD hardware • Re: Which HW to buy
What is your connection speed? Are you planning to use VPN ?L009 is rack mountable, RB5009 also.Statistics: Posted by gigabyte091 — Fri Dec 08, 2023 5:43 am
View ArticleGeneral • Re: Mangle route for WAN2 causing loop
Thanks for the response and config check.Re: routing distanceLogic was that seeing as it's the same gateway, it doesn't matter the order or priority. Current setup works well.Re: dynamic gatewayThere...
View ArticleBeginner Basics • Re: EoIP: guarantee MTU of 1500
Apparently eoip adds an overhead of 42 bytes, so it should fit ok.Statistics: Posted by rplant — Fri Dec 08, 2023 6:01 am
View ArticleContainers • Re: PRTG Probe in Docker Container
@miasharmse84, did you get PRTG container up and running?Statistics: Posted by K0NCTANT1N — Fri Dec 08, 2023 6:46 am
View ArticleWireless Networking • Re: mapLite setup issue local network
This config is a mess right now.This entry is not needed as you already have dhcp_pool0 that is used by DHCP server.Code: /ip pool add name=dhcp ranges=192.168.88.3-192.168.88.254 Why did you disabled...
View ArticleWireless Networking • Mikrotik is blocking few sites
Good afternoon. Please help with the following question. It costs Mikrotik hap lite. The provider provides Internet via PPOE. About half of the sites open normally, but some sites when trying to open...
View ArticleGeneral • Re: RouterOS 7.12.1 and Wireguard - can't ping Windows devices
SOLVED. It was necessary to additionally enable the rule "Virtual machine monitoring (echo request - ICMPv4 - incoming traffic)"Rule "File and Printer Sharing (Echo Request - Incoming ICMPv4 Traffic)"...
View ArticleClik here to view.
General • Re: WireGuard access
Hello i add routesBut no successAfter i connect to wireGuard i cant access /ping any devicebut after i enter peer click on my profile/peer and just click apply (like i double agree Allowed Address...
View ArticleWireless Networking • Re: Mikrotik is blocking few sites
Use /ip firewall mangle to change MSS (maximum segment size) 40 bytes less than your connection MTU. For example, if you have encrypted PPPoE link with MTU=1492, set the mangle rule as follows: / ip...
View ArticleGeneral • Re: Having issues with DHCP client over trunk [SOLVED]
Thank you @vingjfg with your approach I was able to rebuild the configuration using a single bridge and vlanHere is the completed working configuration. The next steps would be to implement load...
View ArticleBeginner Basics • Option 82 in DHCP Snooping IPTV
I have a problem with option 82 in DHCP Snooping for IPTV (JAMBOX)Even though a given port has the TRUST option selected, the IPTV decoder does not receive an address and there is no connection. Other...
View ArticleGeneral • Wifi Interface doesn't give IP with DHCP that is assigned to VLAN
Hello. Very new to RouterOS and the world of networking and I would need some help.I also looked over post 143620 and I cannot see what I did wrong.I created 2 VLANs: VLAN with ID 10 and 20;I attached...
View ArticleGeneral • Re: RDP not working in lan
Hello everyone! Thanks for replies and sorry for long answer.Long story short - none of your advices helped to meI would expect to find the solution in the notebook, is this network a so called...
View ArticleThe User Manager • Admin account not permitted
I reset my router to factory configuration but the admin account doesn't have full rights. The group user i have "System" user have full permission but i don't known anything about it.Statistics:...
View ArticleBeginner Basics • Re: Why adding EoIP interface to bridge lowers MTU to 1458,...
Now, after L2MTU of the offending bridge port is increased, all others (i.e. bridge) have to be increased manually as wellIn my case MTU of VLANs got re-adjusted after a reboot.How does the bridge...
View ArticleThe User Manager • Re: Admin account not permitted
Do a Netinstall with latest RouterOS v7.12.1Statistics: Posted by normis — Fri Dec 08, 2023 10:01 am
View ArticleRouterBOARD hardware • Re: MikroTik cAP ax [cAPGi-5HaxD2HaxD] (r2)
Just bought two cAP ax routers. Factory software v.7.8. Set up two SSIDs: mikrotik-2G and Mikrotik-5G. Everything was alright. Then upgraded to v.7.12: 5GHz radio (and SSID Mikrotik-5G) is gone....
View Article