Beginner Basics • Re: ISP requires VLAN 300 tag
Basically you add VLAN interface (with VLAN ID set to required value) and anchor it to your WAN interface. Then move WAN setup (DHCP client or whatever needed) to the just created VLAN interface. This...
View ArticleBeginner Basics • Re: Forum rules
By adhearing to the rules, I have progressed into becoming better and better at Mikrotik each day. I realy do appreciate all the help I have recieved in this forum.Statistics: Posted by JazzMaster —...
View ArticleWireless Networking • Re: hAP ax lite LTE : Wifi high latency
Yes, I did try LTE firmware upgrade using LTE interface but it still fails.I have the same bad ping round trip time with another deviceReply[1] from 192.168.88.1: bytes=32 time=35.2 ms TTL=64Reply[2]...
View ArticleWireless Networking • Re: Apple devices won't connect
Apple devices cache information about WiFi access points. If you played with configuration on your router, such as changing SSID or security settings, then you can try "forgetting" the networks and...
View ArticleBeginner Basics • IPSEC IKEv2 cannot access LAN devices.
Hello Team,I've been trying to figure out why I can't my LAN devices using IPSEC IKEV2 protocol on my Android device. I use the range 172.16.1.0/24 for LAN, as well for IPSEC.I can access only the...
View ArticleGeneral • V2Ray Client on RouterOS
Hi, I've discovered that we can run a V2Ray server from a mikrotik router using docker containers. But, can we connect to an existing V2Ray server as a client from routeros then route all network...
View ArticleBeginner Basics • Re: DHCP doesn't deliver an address for a gateway
It says "no package included".Better you read the netinstall guide: If you don't download the packages and select on the netinstall the right folder, how do you install them?I follow the guide!...
View ArticleBeginner Basics • Re: poor wifi performance
Obviously yes.If you do not get a connection on that second ethernet port, there is something wrong with your config as a whole.oh yes, port eth8 works fine. But not when configured as internet-facing...
View ArticleBeginner Basics • Re: bandwidth problem with many router
What do you thing about CCR1009-7G-1C-1S+ ?? i could get it for cheap. It is suitable for even 2.5 gbps connection?It's the same for any model, just check test results which are available...
View ArticleGeneral • Re: Wireguard - allowedIPs=0.0.0.0/0
Through routing you determine what goes where. That's irrespective of wireguard or other vpn protocols.Through allowed-address you determine what is allowed entering the tunnel.You may want to read...
View ArticleBeginner Basics • Re: ISP subnet distribution
You can either use switch ACL rules, remembering to also permit broadcast IP addresses in addition each clients unicast IP address, or disable hardware offload and use /ip firewall filter rules after...
View ArticleBeginner Basics • Device without default gateway / NAT
Hello, I have a beginner's question.I have a device for which I cannot configure the IP settings. The IP address is 192.168.111.111 and the subnet mask is 255.255.255.0I have no way to change the...
View ArticleGeneral • Re: IP Hotspot DNS Redirect on V7
Thanks for the reply!So I would just want to accept the traffic to avoid hitting the hotspot? I was wondering if I can create rules and have them stay at the top. I was thinking if you reboot that the...
View ArticleGeneral • Re: Warning message "<network> not a bridge port"...
Mikrotik have likely added the warning as it is a common misconfiguration. RouterOS does not restrict many configuration settings which could be questionable or not sensible making it much more...
View ArticleAnnouncements • Re: v7.13.2 [stable] is released!
i updated 7.13.2 but i cant downrage back . its not work like before i downrageWhat device is it and what is written in the logs?02023-12-23 07:52:45memorysystem, inforouter rebooted22023-12-23...
View ArticleBeginner Basics • Re: Device without default gateway / NAT
Well, two things.Device connected on an ethernet interface of the Mikrotik , this ethernet not a port of the bridge, with its own IP address and mask: eg 192.168.111.1/241. DSTNAT: It is a case of...
View ArticleGeneral • Acess point drop connection
0 2023-12-23 07:52:45 memory system, info router rebooted2 2023-12-23 07:52:50 memory wireless, info AB:3f:44:C3:CC:55@wlan1 established connection on 5180000, SSID 5ghz3 2023-12-23 07:52:52 memory...
View ArticleBeginner Basics • Weird connctions problems after switching to Mikrotik...
Hi. I recently installed a CCR2004 using second WAN I have in my office.Configuration worked well when I've been checking it through the laptop connected directly to the so I went ahead and switched...
View ArticleGeneral • Camera network
Hello all,I would like to ask. Do you think it's a good idea to build the network for the cameras with Mikrotik devices? We are planning to install around 50 PoE cameras. I don't think any of them...
View ArticleBeginner Basics • Re: DHCP client lease expires sometimes, no response from...
I am having exact same issue of not always getting a lease from ISP provider or that it takes too long causing a couple of minutes break or in worst case sometimes a half hour break, this after my ISP...
View Article