The User Manager • Userman vlan id assigment

Hello

I like to know is it possible this scenario.

I have, 10 48 Port cisco Switch (2960X), and 5 mikrotik switch (CRS326-24G-2S+RM) and one MT router 5009
I have 10 vlan-s settup, port based . so every port on switchs are in some vlan.

I like to settup Userman on 5009, and settup switchs to do MAB. So depending of MAC address (end device) of devise connected to port on switch, certan vlan is assign to that port.
For exampe if is VoiP phone Fanvil- assingn vlan 10 (0C:XX:XX:XX:XX:XX), If it is IP Camera assing vlan 30 (98:XX:XX:XX:XX:XX) and all other MAC assing vlan 100.

So, I like to use MAC mask (for manifacture), not to define every mac address like user. All end devices are from same manifacture, and used for one type of job (fanvil voip, hikVision cctv, Mikoritk AP, hp printers) One importnat thnig, is that ONE port on SWITCH is used for ONE end device (one MAC).

Is this settup possible with UserMAN and if not, is it possibe to use freeradius ?

Thanks

Statistics: Posted by nemke — Wed Jun 05, 2024 10:57 pm

---