Hello!
I apologize ahead of time as I am relatively new to Networking and unfortunately have been left to the fires of my predecessor that left no documentation. It's taken a while but I finally have a grasp on the system at hand. I am not too familiar with using CLI so I've been doing everything via winbox.
Currently running on a RB4011iGS+ on version 7.7 from Jan/12/2023.
The situation at hand is that I have a WD My Cloud EX2 Ultra that I am trying to access via FTP using Filezilla from a remote client. The challenge is that the NAS is located on a separate subnet connected to a switch in Ether06. Ether01 is our main for ISP.
Ether 01 is on x.x.254.x
Ether 06 is on x.x.100.x
From here I went to winbox, IP, firewall, NAT and add a new NAT.
What I have done in the general tab: chain dstnat, dst address the public ip, protocol tcp, dst port 21
I have in the action tab: dst-nat, to staticIP of NAS, to ports 21.
when I try to connect to the NAS from remote client, I get an error in connection, but I am able to dial into it via the LAN.
I feel like I am missing something but honestly I don't have any idea. Outside of the accept winbox, there are no other firewall rules in place at the moment.
Thank you so much and I hope to learn as much as I can from everyone!
I apologize ahead of time as I am relatively new to Networking and unfortunately have been left to the fires of my predecessor that left no documentation. It's taken a while but I finally have a grasp on the system at hand. I am not too familiar with using CLI so I've been doing everything via winbox.
Currently running on a RB4011iGS+ on version 7.7 from Jan/12/2023.
The situation at hand is that I have a WD My Cloud EX2 Ultra that I am trying to access via FTP using Filezilla from a remote client. The challenge is that the NAS is located on a separate subnet connected to a switch in Ether06. Ether01 is our main for ISP.
Ether 01 is on x.x.254.x
Ether 06 is on x.x.100.x
From here I went to winbox, IP, firewall, NAT and add a new NAT.
What I have done in the general tab: chain dstnat, dst address the public ip, protocol tcp, dst port 21
I have in the action tab: dst-nat, to staticIP of NAS, to ports 21.
when I try to connect to the NAS from remote client, I get an error in connection, but I am able to dial into it via the LAN.
I feel like I am missing something but honestly I don't have any idea. Outside of the accept winbox, there are no other firewall rules in place at the moment.
Thank you so much and I hope to learn as much as I can from everyone!
Statistics: Posted by dixons117 — Tue Feb 20, 2024 8:56 pm