General • station pseudobridge not working

I know I've done this in the past successfully, but today I was unable to make it work.

I deleted the config so it is completely blank (not default) and then added only the following:

Wireless: Type = station pseudobridge (and I set the ssid and password).

Bridge contains wireless and ether1

That's it. That is the entire configuration. No firewall, nothing else at all.

I connect a device to eth1. However, I am unable to ping that device from the rest of the network.

If I temporarily assign an IP address to the mikrotik bridge, I can ping the mikrotik from the rest of the wifi network, and I can ping the eth1 device from the mikrotik terminal, and I can ping devices in the wifi network from the mikrotik.

However, I am unable to ping the device in eth1 from the rest of the wifi network.

It's acting like the bridge is not working.

Is there some other trick to get pseudobridge working? I realize that it only works with 1 device, and that is fine.

Statistics: Posted by jayooo — Tue Feb 20, 2024 12:19 am

---