Any news on this, I have literally been debugging this same issue for like 3 hours now, and finally found this post!
My LTE Tik is deployed in a rural field, 7 hours round trip for a tech, where we replaced a LHGGM
with dodgy PoE with a shiny new wAPGR-5HacD2HnD that has the Quectel EC200A Revision EC200AEUHAR01A19M16 card thinking this would solve our issues, and was the prudent thing to do given the cost of the truck roll vs the cost of the new wAPGR being cheap.
We have a routed network on a private APN into a MPLS WAN, where I can see routed packets leaving the wAPGR LTE interface fine, and I can see them arriving at the other end of the MPLS WAN, but the reply packets never make it back....
When I Torch the LTE interface I can see the reply entries show up for all the routed inbound traffic, but no routed reply traffic shows up in a PCAP... I thought I was going mad...
I had tried 7.16.2, 7.17.2 7.18.2, 7.19beta6 etc with no luck. My Quectel EC200A firmware is EC200AEUHAR01A19M16, which I believe is the latest.
If there is no resolution, I probably need to build some hacky EoIP tunnel now, and re-engineer the WAN access for this remote site![:(]( "Sad")
My LTE Tik is deployed in a rural field, 7 hours round trip for a tech, where we replaced a LHGGM
with dodgy PoE with a shiny new wAPGR-5HacD2HnD that has the Quectel EC200A Revision EC200AEUHAR01A19M16 card thinking this would solve our issues, and was the prudent thing to do given the cost of the truck roll vs the cost of the new wAPGR being cheap.
We have a routed network on a private APN into a MPLS WAN, where I can see routed packets leaving the wAPGR LTE interface fine, and I can see them arriving at the other end of the MPLS WAN, but the reply packets never make it back....
When I Torch the LTE interface I can see the reply entries show up for all the routed inbound traffic, but no routed reply traffic shows up in a PCAP... I thought I was going mad...
I had tried 7.16.2, 7.17.2 7.18.2, 7.19beta6 etc with no luck. My Quectel EC200A firmware is EC200AEUHAR01A19M16, which I believe is the latest.
If there is no resolution, I probably need to build some hacky EoIP tunnel now, and re-engineer the WAN access for this remote site
Statistics: Posted by nzlme — Fri Mar 28, 2025 6:44 am