Follow the MTU section from the Edge/BNG guide. I use jumbo frames network-wide:How you got it ? I cannot pass 1gb/s . Can you please share your conf and traffic profile(avg size of packets )?
9k L3 MTU, maxed L2 MTU on physical ports/interfaces.
VPLS L2 MTU capped to 9100.
Single bridge config as per MikroTik official docs.
Layer 3 VLAN termination L3 MTU depends on customer, if customer behind VLAN is 1500 then I set 1500 on L3 MTU of the VLAN sub-interface, otherwise it's 9000 MTU end-to-end there as well.
No problem pushing 1Gbps+ with low CPU usage on CCR2004 with VPLS (I don't have more than 1Gbps+ aggregate traffic yet, but still this is decent considering hardware model).
Statistics: Posted by DarkNate — Wed Jan 03, 2024 12:35 pm